The production of doors and windows of sunshine room can't be separated from skilled technicians. The beautiful appearance of a sunshine room is related to how to design the sunshine room. However, the quality is not only related to the materials used, but also closely related to the production level and requirements of the production workers. As the saying goes, "three points of material, seven points of workmanship". Let's take a look at how Shanghai liefan sunshine room is operated in a standardized way.
Installation of sunshine house project
1. Connection of profiles and profiles: the joints of profiles in sunshine room shall not exceed 2mm. The appearance of sunshine room is fresh. The gap of about 2mm is the best for gluing. Any silica gel has its specified shrinkage. 2mm gap can completely avoid the problem of degumming in the sunlight room. There are some rough workmanship joints in the sunshine room, which are generally about 5mm, and some even have more. Even if the gap above 5mm is glued, it may be sealed at that time. However, with the increase of time, after one month or two months, the silica gel shrinks and gradually exceeds its ductility limit, which will definitely cause degumming and water leakage. This is a very normal thing. Even if this situation is repaired, it is very difficult to repair. There is only one way to repair, that is to add new silica gel. In the end, the same situation will still occur. This is one of the reasons why some sunshine houses always fail to repair water leakage.
2. Fine workmanship: the perpendicularity and level of the sunlight room frame are quite standard. Generally, the length of one meter cannot be deviated by 0.5mm. The vertical and horizontal of the sunlight room are directly related to the overall stress situation of the sunlight room. Nowadays, the main material of the roof facade of the sunlight house is glass, which is a bit of high-grade sunlight room. Most of them are double-layer glass or even three-layer glass. The weight of glass itself can be imagined.
3. Frame welding: the important bearing angle in sunlight room must be fully welded. The sunlight room with rough workmanship is mostly spot welding. In the spot welding sunlight room, there is water leakage in a section, and the welding point is oxidized. The consequence is very dangerous.
To sum up, the production of sunshine room is very important. Sunshine room is a project more complicated than doors and windows. It is a high-grade building integrating practicality and beauty. In terms of design, production and installation, professionals and installation team are indispensable. When choosing the construction of sunshine room, we must not blindly pay attention to the price. From design, technology, material selection, even to installation, these are comprehensive Cheng has certain requirements.