In the decoration, everyone will be very concerned about the decoration of doors and windows, looking at simple doors and windows, if the installation is not appropriate, it will lead to many problems.
Door and window decoration notice 1. The gap between doors and windows is too large
If the gap between the doors and windows is too large, and the installation is not vertical to the ground, it is suggested that the master should remove the doors and windows and planed them to match, as long as the installation is vertical. If it is difficult to grasp the verticality, the gasket under the door and window frame can be straightened.
Poor quality of door and window decoration
If the hinge of the swing door is not straight, it will lead to the irregularity of the frame cover and the door and window sash. Reinforce the screw fixing the door and adjust the inclination of the door and window sash and frame sleeve, and it will be good after tidiness. It is recommended not to over screw in the screw at one time, which is convenient for adjustment. If a tightening, it is easy to cause doors and windows too tight or too loose, and there is a sense of swing. The upper screw must be kept straight. It is recommended to screw half and then tighten it.
Door and window decoration notice 3: door leaf switch is not smooth
This is generally due to the incorrect installation of the latch plate of the door. In addition to the unsuitable size of the lock, the biggest reason is that the lock tongue and the lock tongue plate are not aligned. Before installation, make sure to prevent this situation.
Door and window decoration notice 4: sliding door is laborious
The general reason is that the upper and lower track slots are not vertical, and they are not in the same vertical direction. The track can be unloaded first, and the center of the upper and lower rails and the rail groove can be aligned with a vertical ruler.
Door and window decoration notice 5: other precautions
The rigidity of the overall frame is poor, it is difficult to open and close the doors and windows, and shake in the strong wind and heavy rain weather to see if the following can be solved: 1. The selected materials are not suitable, and the hardness is not enough. If the material of aluminum alloy does not meet the requirements. Or the quality is not up to standard. 2. The steel door pocket of plastic door does not meet the standard, the thickness is not more than 1.2, because the manufacturer installed you do not know, you can not measure. So in the installation must ask clearly. 3. The installation is not standard enough. 4. It is invalid to install the wall without fixing.