Now many families are equipped with aluminum alloy windows. The windows are the "eyes" of the house, which plays a very important role. In order to extend the service life of aluminum alloy windows and adhere to the beauty, we need to pay attention to good maintenance in daily life.
1. Push and pull gently when using
In the process of using aluminum alloy window, we should push and pull gently, push and pull in compliance with its beauty; if there is any difficulty, do not force it, you should first remove the fault. Dust accumulation and deformation are the main reasons for the difficulty in pushing and pulling aluminum alloy windows. It is necessary to adhere to the cleaning of door frames, especially the cleaning of the slots. Dust remover and inner dust trap.
2. Do not use strong acid and alkali cleaner
After a rainy day, the rain drops on the glass and window frame should be timely observed, and the water in the chute should be paid special attention to. If the chute is used for a long time and the friction force is added, a small amount of engine oil or a layer of wax oil can be added. Aluminum alloy windows can be cleaned with soft cloth dipped in clean water or neutral detergent. General soap and washing powder can not be used, and detergent and toilet detergent can not be used.
3. Repair and replace the sealing strip in time
Sealing wool top and glass glue are the key to ensure the sealing of aluminum alloy window, heat preservation and waterproof. If there is a drop, it should be repaired and replaced in time.
4. Check whether the parts are damaged regularly
It is necessary to check and tighten the bolts, locate the shaft, wind brace, ground spring, etc., and timely replace the damaged parts and vulnerable parts of the aluminum alloy window. Add lubricating oil regularly and keep it clean and sensitive.
5. Check whether the joint of window frame and wall is loose
Often check the joint of aluminum alloy window frame and wall. If there is looseness for a long time, it is easy to deform the whole structure and make the window unable to be closed and sealed. Therefore, the screw at the joint should be tightened immediately. If the screw foot is loose, a small amount of cement should be mixed with epoxy strong glue for sealing.