徐州附近想过夜电话联系

Welcome to Shanghai liefan doors and windows official website
Good luck and good luck in the installation of aluminum alloy doors and windows
09:00-08:00
At present, the most widely used is the push-pull aluminum alloy window, which can be opened flexibly with a slight push. The bad part is that the two windows can't be opened at the same time, only half of them can be opened at most, the ventilation is relatively poor, and sometimes the sealing is also slightly poor.

Sliding window: divided into left and right, up and down push-pull two kinds. Sliding window has the advantages of not occupying the interior space, beautiful appearance, economical price and good sealing performance. This article talks about the installation method of push-pull aluminum alloy doors and windows. Installation of aluminum alloy windows can not be careless.

Installation of aluminum alloy doors and windows 1. Brick wall equipment

The window frame is repaired with cement, and its size is larger than that of aluminum alloy frame, about 25 mm to 35 mm on each side. Each side of the aluminum alloy window frame is installed on the bracket, and the corner codes need to be fixed on the wall with cement nails. After the completion of the correction with wooden wedge, around the window frame, with tape paper maintenance repair, maintenance around the aluminum alloy appearance damage.

Before installing the aluminum alloy window, inspect the sealing wool flat window, such as whether the glass adhesive has fallen off. Then use a screwdriver to turn the adjusting screw of the side pulley of the spinning frame to retract the pulley to the next horizontal groove. Then screw the top pulley and screw it out from the inside of the pulley.

 Good luck and good luck in the installation of aluminum alloy doors and windows

Installation of aluminum alloy doors and windows

If the glass is in contact with the window frame, the heated inflation will often cause the glass to crack. Just put the lower side in the bright aluminum layer after installing the glass, put it in the backlight flat box, and tighten the screws.

Installation of aluminum alloy doors and windows 3. Sealing groove of hook lock device at the edge of window

The position size of hook device corresponds to the position of hanging hole of casement window. The hook surface of the hook can be at the center line of the lock hole. To the corresponding position, the window frame edge seal groove marks the inside of the punch. M5 self tapping screw lock hook is temporarily bound, and then move the frame edge sealing groove of the window sash to inspect whether the casement window lock can be locked and the lock hook hole diameter 4 will be locked.

If not, you need to check whether the hook height or the deviation around the hook is a problem. Height problem long hook screw loose, screw fixation can be adjusted up or down. The deflection problem that needs to measure the deviation, and then the punch is fixed, can be locked until the window frame.

Push pull aluminum alloy door and window installation method introduced here, installation of aluminum alloy window knowledge you learned? More doors and windows products and related knowledge, please continue to pay attention to China door and window network.


The price of aluminum alloy doors and windows is as low as 1099 yuan   [ Back to home page ] [ Printing ] [ Back to previous page ]    Analysis of the difference between the brand of aluminum alloy doors and windows and those of other brands

Hot Tags:

Product Center