徐州附近想过夜电话联系

Welcome to Shanghai liefan doors and windows official website
Installation method of aluminum alloy doors and windows
Editor: liefan July 12, 2019 08:00:22
With the continuous progress of the production technology of aluminum alloy doors and windows and the continuous upgrading of aluminum alloy profiles, aluminum alloy doors and windows are more and more popular in the market. Nowadays, many consumers choose aluminum alloy doors and windows products. How much do you know about the installation of aluminum alloy doors and windows? Let's take a look at the installation precautions of aluminum alloy doors and windows, as follows:

Before installing all doors, the hole size must be measured to see if it is consistent with the size of the titanium magnesium aluminum alloy door to be installed

1. Hanging door

? first put the hanging wheel or the holder for more than four leaves into the guide rail (the holder should be placed in the middle of the guide rail), then connect the frame and guide rail with screws, put it into the door opening, hang and fix it vertically, insert the hanging wheel on the guide rail into the hanging wheel groove above the door leaf, fix it with screws, and install the locator on the lower side at the overlapping position of the door leaf. If the lock is not symmetrical and cannot be locked, the lock catch of the outer frame can be adjusted up and down. If the two door leaves overlap and deflect, the hanging wheel above can be adjusted up and down,

2. Side door and small folding door

? for installation with large and small holes, the door shall be directly put into the door opening, and the door frame shall be fixed with screws. When installing the pull piece, the pull piece shall be placed horizontally, and then the pull piece shall be fixed with screws; the split line shall be fixed on the door frame first, and then the door shall be fixed in the door opening. After dislocation, check whether the door leaf can be installed flexibly. If the lock position cannot be locked, then check the following two places: A: whether the lock plate outside the lock hole is placed too inside. b: Whether the outer frame of the door is at a 90 degree angle and whether the gap on the other side of the lock is too small can be adjusted between the wall and the outer frame.

3. Double edge swing door

First of all, the inner and outer frames should be disassembled and then put into the hole. According to the size of the wall, screws should be used to connect the inner and outer frames. During the connection process, the sealing plate should be measured to see whether it is consistent with the inner and outer frames. If not, adjust the space between the inside and outside first, and then adjust the sealing plate according to the consistent size. If the sealing plate is small, the joint can be extended 10-15mm. If the board is large, the sealing plate can only be sawed off according to the size of the inner and outer frames. Before covering the sealing plate, the door frame should be fixed on the wall, and finally the sealing plate can be covered.

If the aluminum alloy door leaf is not properly adjusted, check whether the door lock can pass through the lock after the installation of the aluminum alloy.

Install aluminum alloy doors and windows to make your home more beautiful   [ Back to home page ] [ Printing ] [ Back to previous page ]    Cleaning method of aluminum alloy doors and windows

Hot Tags:

Product Center